Vehicles
Sections
601 not categorized PORSCHE 356 CONVERTCan't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 911 1987-89 (includes uncategorized and accessory items) FVD351997TTCS1 This kit convert's the 997 turbo pccb rotors to steel rotors with yellow pagid pads.( only 5-hole, not central lock ) this system is complete with everything that you need to install. Do not ruin your expensive ceramic brake discs on the track. Get ready for racing with the original and much cheaper Porsche motorsport steel brake discs! What's in the box: 4 x 2-piece brake discs (380 x 34 mm - front / 350 x 28 mm - rear) 4 x wear sensors 2 x set ( front and rear ) brake pad set (pagid yellow - rs29 ) 8 x screws for brake caliper 8 x damping plates technical tip: also order stainless steel brake lines (FVD b96 355 97) and racebrake fluid (012 145 ca).
$5,871.80
Make a selection FVD99110042 +140 crank hp & +155 crank tq gain on the turbo and +100 crank hp & +126 crank tq gain on the turbo s. All while offering ultra-smooth drivability and reliability that you expect from your Porsche. Package includes: - FVD my genius handheld flash tool (included). - FVD tuning software FVD99161840mg. - bmc sport filter 47079801. - FVD sound version muffler (reuses factory catalytic converters) bes99105040s. - FVD headers bes99101040s. - FVD exhaust installation kit (everything needed for simple installation). FVD software power gains: max. Power - 485 kw (660 hp) @ 6500rpm max. Torque - 870 nm (642 lb.-ft.) @ 3750rpm max. Speed - 330km/h (206 mph) max. Rpm - 7200 rpm acceleration 0-100 km/h (0-62.5 mph) - 2.9s g...(choose a part on the right to read more)
$6,378.90
Make a selection FSPOR911CB Product details: General Fitment911 1974-77911 1978-83 911 1987-89 911 1984-86
$695.95
Make a selection FVD351997GT2CS2 This kit convert's the 997 turbo GT2's / 997gt3 rs pccb rotors to 997 GT3 cup car steel rotors with green cup car pads ( for cars with central lock only ) this system is complete with everything that you need to install. Do not ruin your expensive ceramic brake discs on the track. Get ready for racing with the original and much cheaper Porsche motorsport steel brake discs! What's in the box: 4 x 2-piece brake discs (380 x 34 mm - front / 350 x 28 mm - rear) 4 x wear sensors 8 x cup brake pads (racing green) 8 x screws for brake caliper 8 x damping plates technical tip: also order stainless steel brake lines (FVD b96 355 97) and racebrake fluid (012 145 ca).
$7,260.00
Make a selection BES99125040S Perfect muffler for those looking for a more aggressive exhaust note without changing the factory catalytic converters. The added benefit is you can reuse your OEM catalytic converters for emissions purposes. + 25 hp & + 19 torque* - reuses OEM cats, perfect for those concerned about warranty. - open muffler design for added power. - weighs 19 lbs. (8,6 kg) - German v2a - x5crni18-10 - 1.4301 stainless steel for improved durability. - 4 on a scale of 1-10 in volume (1 being stock) below 3,000 rpms, 6 on a scale of 1-10 in volume under maximum load (3 being stock). - includes new clamps and muffler straps.* - made in Germany. - modular design for future 100 cell, 200 cell or cat bypass use. - more distinguished ...(choose a part on the right to read more)
$2,655.40
Make a selection BES99120040S Take your 991.1 or 991.2 turbo or turbo s to a new level with these muffler bypass pipes. They produce the wildest sound available on the market today and are a perfect upgrade for level 3 or 4 car used on the track. They produce loud, low, deep tones with exaggerated turbo whistling and sinister gurgling and crackling off throttle. By far the best sound you can get out of your turbo, not to mention being able to shoot flames! The only real drawback is the drone in the cabin which we try to minimalize by stepping down the diameter in 3 stages. Features: - + 35 crank hp & + 25 crank torque - 3 tubing (75mm) that tapers down to 2.25" (57mm) to prevent turbo damage. - weighs 7 lbs. (3,1 kg) - German v2a - x5crni1...(choose a part on the right to read more)
$585.20
Make a selection FVDMK991002 This is an installation kit is for the muffler tips only. It does not include the clamps or gaskets for the catalytic converters. If you need a complete kit with gaskets and clamps for the cats please use our part # FVDmk991003.
$193.92
Make a selection BES99125010SK Are you one of those that are looking for more sound from your Porsche sport exhaust (pse)? Perhaps it's not quite as aggressive as you would like, or your last Porsche just sounded so much better? Don't worry, we have you covered, and the beauty is, you don't have to touch the catalytic converters which is a big no, no with Porsche dealers. With the valves open you receive a far more exotic, rich, deep, turbo motorsport tone and with the valves closed, soft subtle, completely stock sounds. So, absolutely no compromise and you will be thinking, the car really should have left the factory like this! Features: - + 10 crank hp & + 8 crank torque. - weighs 29 lbs. (13 kg) - German v2a - x5crni18-10 - 1.4301 stai...(choose a part on the right to read more)
$4,312.00
Make a selection BES99101260S - + 20 crank hp & + 14 crank torque. - 200 cell hjs tri-metallic "hd" cats. - 2 tubing (50 mm) with motorsport merge collector. - weighs 18.5 lbs. (8.4 kg). - 1.5 lb (9.1 kg) saving's over OEM header. - German v2a - x5crni18-10 - 1.4301 stainless steel for improved durability. - works with OEM sealing rings and clamps. See below for part numbers. - made in Germany. - reduces thermal load and backpressure to for more torque in the mid-range and hp on the top end. Be sure to add new clamps and sealing rings to your order. 2 qty. Clamps are needed, they are part # 99711133690 and 2 qty. Sealing rings are needed, they are part # 98011156100. Our latest development for the GT3 is aimed at those who are looking fo...(choose a part on the right to read more)
$5,286.60
Make a selection GR089091 Cleans throttle bodies inside and outside without dismantling or disconnecting the fuel line. Does not contain methylene chloride, chlorinated solvents, chloroflourocarbons, lead, phosphorus or silicone. General FitmentACCESSORY
$9.87
Make a selection 61380 This roll bar will give your street car a performance look and style. In most cars rear seats and/or convertible top remain in place and useable. 4 point roll bar is made of 1.750 x .120 dom mild steel tube. All necessary installation and mounting hardware with back-up plates is included. * this is not a DOT safety device. General Fitment911 1974-77930 1975-77 911 1978-83 911 1984-86 911 1987-89
$635.19
Make a selection BBI9912020003 The bbi autosport 997 & 991 GT3 / rs exhaust side bypass is a direct replacement for the factory primary side mufflers. The primary mufflers are weigh approximately 44 pounds total while the bbi pipes are 4 pounds in comparison. For durability and protection against corrosion, each system is meticulously tig welded using 304 aerospace grade stainless tubing with lower carbon content. The result is a substantial reduction in weight behind the rear axle which significantly improves handling and less restriction to produce a much more aggressive exhaust note.
$950.00
Make a selection 93011060200 The fuel pressure damper is located at the fuel rail, it smooths out fuel pulses to maintain more constant and consistent fuel pressure. The damper has an internal membrane that can fail causing the excessive fuel pressure since it cannot regulate the pumps constant flow. Excessive fuel pressure can damage the catalytic converter and cause black sooty exhaust. This is a genuine part sourced from Porsche ag in Germany to ensure quality, reliability and precise fitment. Sold individually. 1 necessary per car. View/Change Diagram
$500.50
Make a selection 935FSUSP This light weight, bolt in kit replaces the factory front suspension arms, cross-member, and rubber bushings when converting to a coil over front suspension system. General Fitment911 1965-69911 1970-73 911 1974-77 930 1975-77 911 1978-83 911 1984-86 911 1987-89 914 1970-76
$1,850.00
Make a selection 98656188100PRM Rubber bushing attaches to other end of convertible top push rod (part# 986 561 279 01-prm)
$5.50
Make a selection 99310605180 Allows you to convert to one fan belt to run the fan and alternator like the factory rs versions. Oem part sourced in Germany to ensure quality, reliability and precise fitment. Once installed the alternator will run at the fan speed. That will lessen the inertial load and will add slightly more horsepower and acceleration. - includes fasteners (3 qty. M 6x35) - weighs .4 lbs ( .17 kg) please note: for 993 race car conversions or for cars without a/c we also recommend the corresponding crankshaft pulley, part # 99310205040 sold individually. 1 necessary per car.
From $152.90
Make a selection 992CAT With over 25+ years of Porsche air and water-cooled experience, fabspeed motorsport usa offers a great enhancement for your stock exhaust or aftermarket exhaust on your Porsche 992 Carrera. Using only the highest quality helical valves imported directly from the u.k., our system eliminates any risk of failing exhaust valves. Helical limited in great britain supplies the world's very best exhaust valves to Porsche, ferrari, lamborghini, mclaren, aston martin, and other hypercar manufacturers. Other cheap aftermarket exhaust valves are not able to handle the heat produced by a rear or mid-engine car and are guaranteed to fail, break and rattle. Helical u.k. Imported exhaust valves are bullet-proof and never fai...(choose a part on the right to read more)
$5,245.95
Make a selection 914423285W At last a bracket to hold the end of the 914 accelerator cable when converting to carburation. Easily installed in the casing, this eliminates fabricating your own.
$39.50
Make a selection BES98111200SHD For 2012+ 981 facts: - equal length headers with motorsports merge collector. - 200 cell hd German hjs tri metal sport cats. - t316 lightweight stainless. - primary diameter 45mm outer , 42mm inner - each header weighs 13 lbs. (6 kg) - reduces thermal stress on the motor. - made in Germany please add 2 engine to header gaskets when ordering - 2 qty 99711110731 power: - 981 (2.7l) = + 12 crank hp (9 kw) & + 11 crank torque (15 nm) - 981s (3.4l) = + 16 crank hp (12kw) & 15 crank torque ( 20 nm) our latest development for the 981 is aimed at those who are looking for more torque in the mid-range, a rich, deep exhaust growl. These headers contain the latest hjs cats, they are nicknamed "hd" for high durability ma...(choose a part on the right to read more)
$4,988.50
Make a selection 19004320210 Experience the ultimate comfort of open-top driving with our authentic, high-quality wind deflector. It is designed to match the exact dimensions of the original for a perfect fit and optimal functionality. We have taken great care in adjusting both the height and width to ensure seamless integration with the 911 3.2 Carrera or 930 3.3 turbo models. The wind deflector operates in sync with the convertible top, opening and closing effortlessly for maximum user-friendliness. General Fitment911 1974-77930 1975-77 911 1978-83 911 1984-86 911 1987-89 911 1989-94
$474.10
Make a selection 100211025SSUSA If you have a us model 1980-83 911 SC and are looking to replace your heat exchangers we have some good and bad news. The original heat exchangers (part # 930 211 025 02) are no longer available from Porsche. But, these stainless-steel industries (ssi) heat exchangers will work with modifications. The good news is, once done, you will have more torque and horsepower! Free flow conversion heat exchangers improve sound and performance, while reducing backpressure and thermal load on the motor. These are based off the early style exhausts found on the 1974 2.7 l rs. Those models had a straight through, superior, free flow exhaust design that included a dual inlet muffler. When converting to these heat exchangers y...(choose a part on the right to read more)
$2,863.30
Make a selection
From $38.48
Make a selection © 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |